ASUS ROG STRIX X399-E GAMING BIOS for Resizable BAR
Does this chipset support the Resizable BAR feature? I see that it has the 4G Decoding feature.-Erick
Forum Posts
Memory Interleaving / NUMA Node Setting on 2202 (Zenith Extreme Alpha)
In the 2202 ZEA firmware, the Memory Interleaving option in the Zen DF options is ignored on the first boot when using a TR1950X. This did not happen on the 2101 firmware.If the system is turned on cold, the setting is ignored - resulting in a sing...
Zenith Extreme continues to get code 68 (Check CPU)
Hello Gamers!,Well things have not been going well. At this point I have gone through 2 boards and 2 CPUs with the same exact issue. Every time I try to boot the board I get a post code 68 check CPU. This is with 2 different types of memory, as well ...
Zenith II Extreme Alpha experience, RAIDXper2 and Hyper M.2 X16 Gen 4
BIOS: 1402CPU 3970XRAM: 256 GB 3200 GSkill CAS 16 (F4-3600C16Q2-256GVK)GPU: RTX 3060 Ti in PCIE_1GPU2: Quadro P620 in PCIE_4M.2_1, M.2_2, DIMM_1, DIMM_2 are Samsung 980 Pro 500 GBM.2_3 is 980 Pro 250 GBHyper M.2 Gen 4 with 4 x 980 Pro 500 GB in PCIE_...
Asus X399 Zenith Extreme and a BIOS with a support for a SAM (resizbale BAR) ??
HiI saw that other vendors has published the new BIOS versions for their X399 motherboards with a "resizable bar" support. Does Asus has any plans to publish an update for our x399 boards too?
PRIME TRX40-PRO S - serious problem with bios 1502
After I upgrade bios to 1502, I start rendering with 3ds max and I see my pc's fans are not as noisy as usual. After few minutes, my PC shutdown. CPU Temperature overheat.In bios, I have to change all fans from standard mode to turbo mode then there ...
cpu fans randomly ramping up
My cpu cooler is an Enermax LiqTech TR4 360 where the pump is connected to the aio header and the fans are connected to the cpu fan header.My motherboard is the Rog Strix x399-e gaming.I used fan xpert 4 to configure my fans to run slowly until 50 de...
Zenith Extreme Alpha Problem with DOCP
I have Threadripper1920X with G-Skill F4-3200C14Q-32GTZRX running in DOCP at 3200 and suddenly one morning couldn't boot at that speed.I cannot fix it. Does anybody know what to do?
Double Booting Issue
Right iv had my Zenith Since threadripper was release has anyone else got the issue when they turn on there pc where it double loads
Problem screwing in Threadripper cpu on Zenith II Extreme Alpha.
Pretty sure, I have a Foxconn socket. I have the cpu slotted in, and when I tighten the three screws in I don't hear the pop from the torque wrench. The screw starts refusing to move without applying significantly more force. I stop at this point to ...
