So I finally but my 4TB WD red pro x4 raid 0 to test on this Zenith Extreme TR x399 BIOS 0801, using the mentioned raid controller on a PCIe card, CrystalDiskMark reported >800 1GB qt32t1 seq speed for empty drive so all seems well. Now with 15% i...
Hello,I have issues with my setup with very high temperatures on a moderate overclock and will appreciate any help.System setup:Mobo: Asus Zenith Extreme X399CPU: AMD Threadripper 1950xRAM: 8x8 GB G-Skill Trident Z RGB DDR4-3200 CL-14Video: SLI 2 x N...
Hi community,I noticed that my STRIX X399 board seemingly randomly forgets I set my chassis fans to a manual curve. It is really only the setting for the curve that jumps back from "Manual" to "Standard". This happens roughly every 3 reboots. I have ...
HiFollowing this tutorial exactlyhttps://youtu.be/csiqG_rkSWI?t=300However when I get to the point where I need to choose the AMD-RAID Config Device under System Devices it is missing.Am I running a wrong version of Windows 10 or?Any help appreciated...
Might I suggest to Asus that they ship this board with a right-angled 4-pin power molex cable? I popped the board into a SuperMicro case, and it's practically flush up against the wall (near the bottom of the board), making this cable a necessity...a...
I have a Zenith Extreme motherboard and a 1950x Threadripper. I purchased a 128GB Corsair PC3000 Memory kit (CMK128GX4M8B3000C16 ) from NewEgg that according to them, was compatible with Threadripper. Bottom line is if all 8 modules are installed, th...
Am running BIOS 801 for stability, though just checked and it seems the latest 'official' is 804.Considering purchase of new 128GB DIMM kit1- Is it possible to reach 3200Mhz or higher with 128GB RAM?2- Any specific recommendations other than the pref...
Hi, I've been suffering from system instability for 3 weeks now. When I first built my PC I was able to use it for a week and a half for workstation purposes but also for gaming without running into any problems. I did not overclock the CPU at all, t...
Hello, I just configured but board and upon first boot the OLED display is not working; I tried checking the cable connections but it seems to be okay. Aura LED strip on the shroud works as it should. So far the board has not any other issues and to ...
HiHaving a difficult time with something that should be so simple. Trying to install a M.2 drive in my new Zenith Extreme mobo but to do so I have to first unscrew 3 tiny Phillips screws on the cover (see attached).The problem is that they are screwe...
