There's a new BIOS version 2301 available for both non-WiFi and WiFi models:*Improved system performance *Update CPU microcode for security issue.The new microcode version is CC (previously was B4).I updated and my Asus 10GbE networking PCIe card see...
Apologies if this is the wrong place to post- I'm at a dead end and cannot figure this out.SYSTEM - ROG Strix z490-E Gaming - i7 10700k - Gigabyte RTX 2080 Super (Gaming OC)I recently swapped my motherboard from a MSI z490 board to the ASUS ROG Strix...
I have been using a Samsung 960 Evo NVME M2 as my boot drive since i built this computer about 1 1/2 years ago, and I cannot install the drivers from Samsung or use the Samsung Magician tool to observe or tweak my drive. I have a Rog Maximus Hero XI...
So i have my Ek pump plugged into the W_Pump Header on Maximus XII Hero board and i set it up on the bios,But it keeps reverting back to 100%When i look on Dual Intelligent ROG Software the pump profile line matches the bios settings, but the pump di...
I got this motherboard, because low dpc latency and it is good for gaming. I couldn't wonder more, i/o shield is so massive, that it blocks pci-e slot, which like wtf. And largest gpu you can fit is - 1060, wtf this is expensive gaming motherboard......
As you can see in the above picture if it actually took if not I will fix it. The top of the pic is when fresh driver update the bottom one is with rolled back driver. 1.0.0.9. I have no issues 99% of the time with this driver compared to constant...
Hi, I've read many reports of people having trouble waking up their computers from hibernate and sleep mode , but couldn't find any solution , and my case is a bit odd:When I leave my computer (Z390-E, i9 9900K) with nothing to do, the power led w...
Is this what it should read? Shouldn't it read Firmware > AsusTek or something like that?Did I miss any drivers or something?EDIT: On the Asus Rog strix Z490-I with 10900K
Hi,I went back to an Asus Motherboard since two days (maximus hero XI) and I notice that my boot time is longer than I was used to before on an aorus master. 16seconds vs 10seconds. I know, it's not a big deal at all but i wanted to know how I can im...
I have No PWM Control on my DDC 3.2 PWM Water pump, using the PWM Water pump header. Currently stuck at 100% tried all other headers but it does the same. I have tried setting the upper , mid and lower temp and speed rating in the bios but it seems ...
