This is the reply I got.
Dear ****,
That is correct.
Please just make sure absolutely all inputs have their designated cables connected firmly.
Should you have any further questions, please do not hesitate to get back in touch with us.
Best Regards,
Andy
ASUS Technical Support
http://ro.asus.com/http://support.asus.com/We kindly invite you to provide us your positive feedback.
For this investigation to be as relevant as possible please reply to this
email within 5 days.
Please keep the history of your e-mails sent to you by our Support Staff. Otherwise, we won't be able to analyse your case properly.
---------- Original Message ----------
From :****.****@outlook.com
Sent : 3/25/2015 10:53:45 AM
To : "techsupport@asus.com"
Subject : Re:Re: Motherboard MAXIMUS VI EXTREME [ID=RWTM20150324041057317-817]
[CASEID=WTM201503251853441102]
By CPU connector you mean the 6-pin left of the board right?
---------- Original Message ----------
From:ASUS TSD
To:****.****@outlook.com
Date:2015-03-25 09:34:30
Dear ****,
My name is Andy and I will try my best to assist you issue.
Please feel free to rate our service according to the solution provided in the
questionnaire that will be sent to you shortly after our reply to your inquiry.
Concerning your message about the MAXIMUS VI Extreme, from the provided pictures
A0 q-code is the one displayed which is a non-error, that actually means everything is
OK and control has been changed to IDE.
Now in the situation that the "00" code appears in the Q-CODE area, then there are a
couple of steps to be taken to ensure that all human errors are out of discussion.
Are you booting with both video cards inserted or is it only single card booting?
If both coupled are they both powered by both 6pin connectors which would mean 4
total connectors, 2 on each individial graphics card.
Was the motherboard tested with only one RAM module installed in the correct slot,
either A1 or B1.
Is the CPU power connector properly inserted?.
After verifying these steps and if all still do not provide you with any change, it will be
required in this situation to contact the retailer for warranty of your component.
Should you have any further questions, please do not hesitate to get back in touch with
us.
Best Regards,
Andy