Dear friends, I am literally going crazy. The noise of the pump always at maximum is drilling my brain. I connected the system following the instruction manual. Radiator fans connected to CPU fan with the supplied 3in1 cable, the sata cable to the po...
I just finished installing my Ryujin 360 and everything works perfectly. At the first start, the brightness of the oled display was quite good but then, after the firmware update, it deteriorated significantly. Is there any method to increase the bri...
Hey friends. First, yeah, I have complained about the Ryujin 360 in the past and have been pretty charged up about it as well. I have had one on an Intel build now for a while and did not like how the display for it actually shows the CPU temp as w...
After several tests on a ROGMXIIF motherboardI tested the different connections of the fansCurrently:ROG AIO on W + Pump or AIO Pump(no difference for me)Fans: ROG AIOFan 1 CPU on CMFan 2 CPU Opt on CMFan 3 On ROG AIO.in fact I only have a fan connec...
Hey,I got a problem with my Radiator fans for the Ryujin 360.The fans only start to run at 40% PWM; the software how ever tells that they should run at 20% PWM already with 400 and 30% PWM 600.When I use the smart mode at 30% PWM or using fixed spins...
HelloSo my Ryujin was working perfectly as intended and I could control the lights and the display with Aura and Livedash but recently it stopped working.So there's no display and the lights are just doing the rainbow wave.First thing I did was unins...
As the title says, i used a little bit of water and a soft cloth and the cover has lost the mirror effect, Asus gaves a replacement for this? and how is this product so bad that it loses that effect after one cleaning, and is a expensive AIO.
Hello today I replaced my asus rog ryujin 360 cooler fans with corsair ll120 fans I was unable to control the micro fan via software after changing the fans. Is this normal?
Hi Team,I have a Ryujin 360 setup on my Rog Zenith Extreme motherboard with a 2950x. I have my fans hooked up to the cooler, the cooler is hooked up to the CPU_FAN header, SATA power, and hooked up to the USB 2.0 header. When I boot the system it pos...
SO i haven't tried the AIO-Pump and presently have it connected to the CPU Fan instead. Is one better than the other, for example connecting the pump header to the AIO and then the Rad-Fan's to the CPU fan? or running everything off just one or the o...
