Z370 / Z390
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Cannot boot after resoting from backup

My motherboard: Z390 gaming-i. System (Windows 10) is installed on partition of NVME. GPT partitioning/UEFI boot. I did system restore from backup couple last times no problem. But now I met with this error again. The way I do it is: I go into BIOS a...

empleat by Level 10
  • 733 Views
  • 0 replies
  • 0 kudos

Motherboard will not show option for resizeable bar.

As the title says, currently emailing with ROG support. Full hardware list is Maxmimus XI WifiI9-9900k32gb Royal Trident ZGigabyte OC Gaming Rev 2.0 30801000+ Gold plus EVGA supernova PSUI've updated to both 2004 an 1902 in an attempt to get it to sh...

Sound coming out of wrong device/not playing (2 sound outputs)

I Am on Windows 10 64 bit 21H2, build 19044.1706. I have installed sound drivers and have realtek audio console. It was working fine weeks, but all of the sudden I started having issues:I have 2 audio sources, speakers in the back and headphones conn...

empleat by Level 10
  • 4495 Views
  • 17 replies
  • 0 kudos

ROGSTRIXZ390-F GAMING Motherboard Update

Hi thereApologies but wanted clarification as alot of answers i could find are old - i have the ROGSTRIX Z390-F Gaming motherboard. If i update the bios do i lose my OC profile set up?

Above 4G decoding - floaty mouse

My specs:i5 9600kfG.skill trident z 3200mhz cl 16, 2x8GBGeForce RTX™ 3070 VENTUS 3X OC - 8GB VramASUS Z390-i gamingRM650xI activated Above 4G decoding in BIOS, after I read it helped with performance. However: my mouse input lag improved when moving...

empleat by Level 10
  • 27533 Views
  • 7 replies
  • 0 kudos

Z390 upgrade causing lower benchmark scores.

Hey guys!So I recently upgraded from a Z370 Maximus X Hero to a Z390 Maximus XI Hero. I know it was most likely a waste of money, but I just wanted the potential overclocking headroom for my 9900K. So I know this is probably going to be laughed at bu...

STRIX-Z370-I USB Type-C port physical issue with IO shield padding

To get a USB Type-C cable to reliably make connection I have to manually hold the connector into the port, compressing the IO shield padding. Is this port in compliance with the USB spec's keep-out-zone?Has there been a revised version of the board o...

vithos by Level 7
  • 8108 Views
  • 12 replies
  • 0 kudos