memory problem

[trainut]

pc working fine for weeks ,at 4.5 i7 with 32 gbs fury hyper x. ddr4 2666 mhz this morning for no reason I can see no boot. looked up q codes 1st was 32 after a reset and clear c mos 99 I then replaced with 16 gb g skill 3000 MHz which I had spare booted up fine / question is how can I test my 32 gb memory fo faults dave

[FuryA]

trainut wrote:
pc working fine for weeks ,at 4.5 i7 with 32 gbs fury hyper x. ddr4 2666 mhz this morning for no reason I can see no boot. looked up q codes 1st was 32 after a reset and clear c mos 99 I then replaced with 16 gb g skill 3000 MHz which I had spare booted up fine / question is how can I test my 32 gb memory fo faults dave

hi trainut

Does Your memory modules have different XMP SPD settings can enable?
You can try loading different XMP or try to swap Memory slot

[trainut]

my modules are the same 15-15-15-35, I have had a very close look at the labels. they seem to be two16gb kits would I be better using ie,. 1-3and2-4 splitting the two kits that way also I , keep getting a notice I have never seen before this is just before I shut down but not always ( DIPAWAYMODE) stack overflow .??????? what is it any idea rgds,.

[NemesisChild]

Do not split the sets, run each set in each dual channel configuration.
However, it's not advisable to run mixed sets of memory, even if it's the same brand & model.

Did you try booting/posting after returning the bios settings to stock/default?

You might want to run memtest on each set individually.

[trainut]

NemesisChild wrote:
Do not split the sets, run each set in each dual channel configuration.
However, it's not advisable to run mixed sets of memory, even if it's the same brand & model.

Did you try booting/posting after returning the bios settings to stock/default?

You might want to run memtest on each set individually.

ok so I run one set 1&2 the other set 3&4 is that correct, also how do I do a mem test dave ps sorry since installing my ripjaw ram boot ok

[NemesisChild]

Run one matched set in slots A1 & B1 and the other matched set in slots A2 & B2.

Memtest: http://www.memtest86.com/

[Chino]

trainut wrote:
32 gbs fury hyper x. ddr4 2666 mhz

Is that a single memory kit?

[trainut]

no mate I added 16 gbs to a 16 kit I had in already I was very carefull to get the same timings

[trainut]

results, done the test on the ram/ 16 gb in 1and2 ok/ other 16 gb in 1and 2 all ok, all four 32gb in 1234 tested all ok booted up fine as normal, looked in event for the results but at my age a bit above my pay grade lol. now could the no boot have resulted from my overclock only 4.5 @ 1.20 volt seems to be working fine now but I am at stock 4mhz but I could do with the extra MHz boost for my flight sim again chaps thanks for all your input.