problem when run pc

[lello22]

hello when I turn the PC i have 2 / 3fakeboot after i do hard reset ON push-button and start but i look no set frequency.
exemple set frequenze 4.4 i look 3.7 then restart and finally work
why???

[Chino]

If your system goes into a Boot loop during overclocking, it means that your overclock is not stable. You need to tweak it some more.

[Menthol]

lello22, I am not sure I understand your question but from a cols start or when changing bios settings there can be some memory training that can cause what seems like a double start or slow start, when you change the frequency like you say from default to 4,4 it will not show that in the bios but will change when you f10 save and reboot
and as Chino states if your system is unstable its unstable

[lello22]

yesterday I mounted hurt the Rams
Today I am again forced vcore for 4.4
yesterday vcore 1.827 for 4.4 with ram default 2133 but badly fitted
today vcore 1.296 for 4.4 with accommodation ram bat are defoult 2133
excuse for bad english

[Chino]

Keep increasing the vcore in 0.01V increments until you are stable.

[lello22]

now i am test with realbench
frequency 4.4
vcore 1.296
cache 40
vchace 1.2496
ram 2133
temp 74 70 76 72 73 68 ( highest high )

if I end testing positive this parameters its good or pushed too
regards

[lello22]

the problen with ram 2133 no exist
the problem exist with ram 2800

[Chino]

lello22 wrote:
the problen with ram 2133 no exist
the problem exist with ram 2800

It's not the same running a 4.4GHz overclock with 2133MHz RAM than running it with 2800MHz RAM. Most of the time, running faster RAM will require more Vcore. And sometimes you need to tweak the System Agent Voltage as well.

[lello22]

thanks for answer
what temperatur can reach

[Chino]

Personally I try to keep my temperatures below 80C at all times.