X99
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

New Computer, which Mainboard? V Edition 10?

I'm going to buy a new computer soon. After I had significant problems with the Rampage V Extreme, I'm not sure if I should really get the V Edition10.What is your opinion about this?

HK007 by Level 7
  • 1829 Views
  • 3 replies
  • 0 kudos

Rampage 5 extreme 10th edition and asus Thunder bolt card

So im having this issue with the asus thunderbolt card where once I enable it in the bios and boot to windows and see of its working and it's not. However once I restart the mobo no longer posts. My pc specs are as follows:5930k2 gtx 1080 in all32gb ...

Rampage v not letting hdd to boot into windows

hello, this morning my pc ran perfectly without any issues. it was afternoon the pc started to show problems. it just does not boot windows up. when i start the pc the asus rog logo appears with the text written at the bottom which is "press f9 to go...

R5E10 VCCIO won't stay at what's it set to.

Hey guys. I've noticed that the VCCIO for both PCH and CPU scales up too high as the CPU voltage goes up. Even set fully manual to 1.05, it will go upto 1.35-1.39 during system load.Is it normal for the vccio voltages to be linked more or less direc...

Intel Virtualisation Technology throttles BCLK

Hello,my 5960X runs prime stable at 4.5/4.2 GHZ (1.3V). I only used multiplicator. BCLK is at 100 MHZ. Spread Spectrum is off All power saving fuctions are deactivated in UEFI. But when i activate Intel-VT in UEFI, my BCLK goes down to 96-98 MHZ, so ...

Dwarf79 by Level 7
  • 1230 Views
  • 0 replies
  • 0 kudos

Windows 10 and DTS Connect!

Yesterday I've updated to Windows 10, but I can't get DTS connect over S/PDIF to work. On 8.1 the S/PDIF and DTS connect were working perfectly, but not on Windows 10. I've installed the latest audio drivers from ASUS support site.Using Windows 10 Up...

VIPER by Level 7
  • 52348 Views
  • 28 replies
  • 0 kudos

DTS Interactive over Optical issues - Windows 10

Hi All,Anyone know how to progress with getting this issue resolved. Centre and Left Surround channels get stuck at 100% and are not affected by the volume slider (all other channels raise/lower fine)Workaround is to change the default format back to...

Processor getting hot too quickly

Hi everyone, I have a problem with my build. My computer was in a sleep mode for few days, and when I tried to boot it, it shut down after 5 seconds. I tried an other time and acheived to be in the BIOS for few seconds enough to notice that my proces...

V10 Edition and how are Fan Headers Linked?

I recently swapped from a "normal" R5E to the V10 and the new Fan Expert (Version 4 now, not Version 3 like on the R5E) isn't working too well anymore.Often when I reboot, the Fan Expert says "CPU fan has changed you need to re run auto tuning..." ev...