HiI am having a problem with my Rampage V motherboard. When I disconnect the power cable or there is a power outage and i try to start the computer the motherboard says 00 in the Q-Code panel. Then I have to hold the power button to turn of the compu...
Hello guys.I am using 16 GB Corsair Dominator Platinum 3000 MHz. So it is 4x4. So in BIOS it reads only as frequency 2133 MHz. I just put in new cards after changing my old 2666 MHz cards. But this also did happend with the old cards.So I am wonderin...
When booting my system, it usually power cycles multiple times until one of the following things occur: Successful Boot with Compatibility Support Module (CSM) Disabled No VGA Detected Beep Code (1 Long, 3 Short) with CSM Disabled [Occurs the m...
Our fuse tripped earlier. I have a gaming system also used as a mining rig with 5 x 1080ti cards. After the fuse tripped (which does occur every few weeks), the mobo lights are lit, but it will not attempt to power on at all. I stripped out 4 of the...
I've spent the past few hours combing through posts about this DAC here and found plenty of users experiencing issues. For myself, the DAC works great with my headphones, but I recently tried to use a mic through it (that works fine in the rear I/O o...
Hello my friends I am from greece and i have the pc my systems parts is i7-5930k Asus rampage v extreme Asus gtx 980 matrix sli corsair vengeance 16 gb m2 Kingston predator 240 gb wd 1tb corsair h110i gtx corsair ax1200i. For a long time my system sh...
So over the past few weeks ive had some stability issues with my system, resently had video driver crash and aura failing to sync the gpu i planned on doing a clean install. Last night my pc turned off and restarted, qcode D6 shown. Cleared CMOS and ...
Strix 1902 beta.When will be 1902 release version(not beta) this UEFI?
Hi guys... i have a Strix X99 motherboard. Some month ago i activated ERB to S4+S5, and my usb devices get off when i turn off the PC (so my PSU is compatible). I recently moved the PC in other house and when i connected all USB devices (same place a...
so guys i was encoding and got a bluescreen.Hit the retry button, lower the cpu multiplyer a bit and now i only get a 6F error in the MB and i cant even enter in the bios no metter what i try.Need help!
