Last night shutdown the pc like i usually do went to sleep woke up turned on the pc it kept powering on and off around 6 times then turned off , i tried to power it on again and the power turned on but had no post screen monitor had no signal and jus...
So my new Rampage V arrived yesterday, the build went smooth all until I started powering up. The very first boot took a long time and I noticed the error code 79. I got into the Bios(#1), checked it out a bit and did a couple of restarts. Each time...
I am new to ROG, but not new to building PC's - have at least 25 years experience.If we define different periods of the boot process:part a - the black part on the monitor when you first powerpart b - the time the BIOS screen (logo) is visiblepart c...
I have tried to install the new USB driver on a fresh install of windows with no success. I keep getting the same error message even with the older driver. I tried the new driver first without success then installed the older driver-it gave me the sa...
Hi, I was running GPUz when I noticed my bus is running at 2.0. I thought It was meant to run at PCIe 3.0?I found a site linked below, tried that option, sadly made no difference.http://www.trickmasterpc.com/force-enable-gen3-pcie-3.htmlNot too sure...
Hi Guys,Recently did a new build with all new gear, and I'm a bit stumped at some of the issues I get sometimes...Issue #1 Sometimes only half my ram is detected, windows says I have 16GB, whilst at the same time CPU-Z says I have 32GB, Bios also so...
Noticed my 5930k running at 71C with prime95 withe a 4.2G overclock. Is this temp too high? What are the limits here? Thanks.
I am running an i7 5960x with corsair dominator platinum 3000 MHz XMP 2.0 64 GB 8 x 8 GbOk. Basically here is my problem;WIth XMP activated, the Ram will run @ 3000 MHz,but only 32 gigs of the full 64 get detected in XMP mode.AND the processor runs s...
Hi all,I have 2 RAID arrays, 2 x 240GB SSD in RAID0 and 4 x 2TB spinning disk in RAID10. I set these up as arrays before installing the OS and got everything working. Was able to install all drivers and start using the machine successfully.The mach...
Hi,Could someone please clarify this for me please?It is in relation to UEFI.Q1: My understanding was if the media device has UEFI at the start of it in the bios, then it is UEFI compatible.If it has P1, P2 etc then it's not running via UEFI but via ...
