I got a i9 11900k and a extreme maximus XIII board.
So i found this video on how to lower the volt and get better temps,
https://www.youtube.com/watch?v=QV2x8FzNP1k
But in my bios then the offset voltage is set to auto and i cant change it.
Then the ...
On my motherboard there is a usb port with a white frame around it and a text that says Bios.
Can i use this port for a usb port since im low on extra usb ports.
I just bought this mini table fan that runs on usb power and i tryed to connect it to th...
Recently i found out there is a driver problem with my Sonic studio virtual mixer !
It has this yellow warning sign with a ! mark and i just updated my drivers and its still a problem..how do i fix this ?
Im still looking for a 4 k monitor but it must be with FALD
Full array local dimming zone and NOT edge lit.
I tryed to look up several asus monitors or the few that exist.
But they dont tell me what Led type it is.
And the support dont even know what...
Hi
Im looking on this monitor since it just released in Eu where i live.
https://rog.asus.com/dk/monitors/27-to-31-5-inches/rog-swift-pg27uqr-model/spec/
Can anyone recommend it or know anything about it ?
Good and bad details..
Does it have ips glow...
Edit:The ofset - power was set to auto, so now its set to ofset - 0.075 and i can see my mhz increased to 4300 and temps 60-65 using cinebench.But why dosent it ramps up to 5100 or 5300 mhz using stress test ?Why does it stay on 4100-4300 mhz ?I dont...
I disabled the multi-core enhancement. That helped with the temps not reaching 95 cBut it also changed the mhz clocks to a lower rate than current set as OC
I have never tryed to change the w rates for anything so im a bit scared and to green for doi...
When i run stress test then the volt dosent go above 1.3800 v
But when the stress test stops then the volt is 1.4400 ish since i use idle cpu power management in windows
