After using the monitor for close to a year, it has gotten to the point where the fans speed up and slow down constantly. My monitor is perfect, no backlight bleed or dead pixels so instead of submitting for an RMA and getting another panel. I decide...

I have a RVE10 with a 6950x paired up with two 1080 classifieds. I'm using the high bandwidth bridge and they are both in the 1st and 3rd slot. Looking at GPUZ one card is running at x16 3.0 but the other is running at x8.0 3.0. I went into the bios ...

I have the following board and CPU. I have two 1080 gtx classified and last week they were both in the 1st and 3rd PCI slot and were both running at x16 3.0. A couple days ago I put them under water and used the dual slot EK terminal thing so natural...

I'm having issues with the new Rampage V that I just bought last week. I have the G.Skill 16gb ddr4-3000 ram and the RVE will read the entire 16gb just fine without the xmp and stock settings. However, I enabled the XMP without changing anything else...