Hello everyone.I like this rog z790-i itx motherboard but I want to install just one nvme drive on the bottom m.2 slot (chipset side).The issue is my drive has a heatsink and it's physically impossible to install it without removing the asus nvme hea...
Owners of any of these FE cards (3070/TI, 3080/TI, 3090/TI) and Z490-G motherboard, does the card shroud hitting the dimm slots or not?Picture of what I'm talking about:https://imgur.com/a/6FNfgrD
Nate152 wrote:It's certainly a tight fit.Once you get it past the clips and fully seated, does it fit better with little to no pressure on the ram clips? It looks like it should unless it's already fully seated.If you're uncomfortable with any pressu...
Nate152 wrote:I would think any gpu would fit just fine with either type of clip even with a backplate.You may run into issues if you were trying to use something like the EK Vector FE water block with the active backplate.My 3070 Ti FE is hitting th...
Ok I've figured it out.ASUS uses two versions of those retention clips on the ram slots.There are two versions of the Z490-G. I'm not sure when ASUS replaced those clips. (see picture below)But I've found that this is not the only motherboard ASUS di...
Nate152 wrote:Hi cmosfxxWelcome to the ROG forum.At 6:05 of the video, it looks like they have an FE gpu installed.Thanks! He cuts the video right on the point though. I'll try to contact him.
