Hello,I built my first computer and have a problem.I made a OC to my memory for 3200 speed (this is the manufacturer's speed)And every time I turn on the computer or it takes about a minute to turn on or that code jumps (8)thus is my setup:
skellattarr wrote:try pulling your CPU out and check pins and reseat the CPU then check all your power connections and make sure memory is seated okI've checked before.Everything was fine.Today the code 04 also jumped
gupsterg wrote:Q-Code: 8 can occur for a number of reasons. I have seen it occur even on a crash where CPU is sufficiently powered. I have seen it on flaky OC profile. I have seen it when RAM is having an issue. All in all it just seems an all round ...
liakou wrote:Yeah, that is because some people, most probably with Low-end CPUs have plugged only one cable and their system boots and works. Fact is though that a MID/HIGH end CPU will get insufficient power by not having the 4pin connected as well....
DavidFpv wrote:The pc is boot but with one crash...Anyway I'll buy a cable in the next few days ... But is it critical if I use DCOP settings like this? Except that the computer crashes first and then reboots everything works properlyhttps://s.click....
