Have a x670e-e Gaming with a Ryzen 7950x CPU. Also have an RTX 4090 I was just using for rendering and was planning to use the built in GPU for display. That said, I have the iGPU set as primary and there was an option to force and enabled that as ...
X670e-e gaming motherboard with 64GB of ram and no GPU installed. I have the iGPU configured as primary in the bios and connected to the monitor thru the displayport. When I'm navigating thru the numerous bios screens on my AMD board the screen wil...
I run the bios fan control and have tried in both situations to run optimize All or whatever it is. Motherboard is x670e-e gaming. Fans are:
https://www.amazon.com/dp/B0BXSJYFMJ?ref=ppx_yo2ov_dt_b_product_details&th=1
Here's the deal. If I run opt...
When I first bought my my x670e Crosshair Hero couldn't get the thing to post. Had the latest bios settings, kept getting various coded. Tried adding and removing PCIe cards and moving memory around. Nothing worked. Ended up pulling the battery, ...
I have a set of fans in the following two connections on the motherboardI went into the bios to adjust the qfan curve on them and then looked at the monitoring screens for the fan speeds.Chassis Fan 2 and Chassis Fan 3 are showing fan activity includ...
I was curious about this " did you follow the instructions which says to load defaults first, reboot and then flash ?"
I saw that text and have done that but if you use the bios flash feature by plugging in the USB stick into the port on the back and...
If I clear the CMOS it then boots into the BIOS and I can apply the settings agan.I applied all my settings again manually after the bios upgrade except the fan settings. Saved and rebooted. Then went into the bios again and set the fan curves and ...
No, I have this thing slid into a rack so can't take it apart right now however I have always had the raid card in the slot closest to the CPU and it would come up. Even had a third card in at the time which I don't now. Only difference is I now ha...
Thanks Nate. That was the next plan. Stabilize where I'm at and then start tweaking. Not sure how much those kind of adjustments really effect things in the end.Guessing without those settings set to 0.01 the board is kind of doing it's own thing ...