I get this issue too with XMP enabled , I noticed applying XMP would raise my VCCIO too high @ 1.328 v so if i lower it my double post would stop & as far as i can tell everything apparently looks stable in OS environment, mind you with this platform...
Hmm.. after I installed win 10 on my M.2 i get boot loop like for 4 times everytime i clear cmos then it gets into windows 10. Mine takes along time to boot too...Mine stops the boot loop when I enable x4 mode in advanced on-board devices m.2 I was ...
Hi did you figure out the best settings for your issue?, I have similiar issue but mine is the VCCIO being raised to 1.328v while VCCSA sits at 1.18v xmp 3200mhz i can lower it to stop the double post i am getting but can't figure out if it's safe li...
Zeroed85 wrote:I have just installed a Maximus X Hero with an 8700K and Dominator Platinum 2x8GB 3200MHz. Simply enabling XMP results in a POST failure. The onboard diagnostic LED under the QLed indicator shines yellow indication a ram issue. QLed co...