I dialed in tRAS = tRCD(RD) + tRTP. (I could use that formula all the way down to 23 without issue.) tRCD is set to 15, and tRTP is set to 5. When I dialed in a tRAS or 20 the board sets it to 21. In the bios menu it's set to 20, but always shows 21 ...

I noticed under the overclocking setting there's an option to treat the numa nodes as separate nodes each. However, I receive a warning about accessing the oc settings. Is it safe to enable treating the four chiplets on the 3990x as separate numa nod...

I'm about to power up my system for the first time. While digging through the manual to make sure I did not forget anything, I noticed ln2 jumpers do not have anything on them. Do I need to put the jumper on to disable ln2 mode?

When I installed the board I did not remove the top middle EATX standoff from the case. The Enthoo Elite is setup for 9 screws by default. Looking at pictures of the back of the board it does not look like any component exists there that could cause...

I'm using the Dimm .2 slot with one nvme drive, overclocking a 64 core cpu, a low power graphics card, and overclocking the ram. I just have 1 SATA disk attached.Is EATX12V_1, EATX12V_2, and EATX12V_3 all required? Is it possible to get away with not...