I just added a 5080 to the system. I think under max load the system can hit 800 to 1,000 watts pulled. Other than the 5080, my pcie lanes are populated by 2 to 4 NVME x4 drives, and wireless card. I'm not running sli. Think there's a scenario where ...

I dialed in tRAS = tRCD(RD) + tRTP. (I could use that formula all the way down to 23 without issue.) tRCD is set to 15, and tRTP is set to 5. When I dialed in a tRAS or 20 the board sets it to 21. In the bios menu it's set to 20, but always shows 21 ...

I noticed under the overclocking setting there's an option to treat the numa nodes as separate nodes each. However, I receive a warning about accessing the oc settings. Is it safe to enable treating the four chiplets on the 3990x as separate numa nod...

I'm about to power up my system for the first time. While digging through the manual to make sure I did not forget anything, I noticed ln2 jumpers do not have anything on them. Do I need to put the jumper on to disable ln2 mode?

When I installed the board I did not remove the top middle EATX standoff from the case. The Enthoo Elite is setup for 9 screws by default. Looking at pictures of the back of the board it does not look like any component exists there that could cause...