©ASUSTEK COMPUTER INC. ALL RIGHTS RESERVED.

hunuok · 04-12-2012

Hello to everyone on this forum.I have a strange issue involving my rig (see sig) on cold startup.On cold boot, display is not shown in surround (ie 3 monitors).After login, Lucid Virtu crashes, NV Control panel crashes and only two GTX480s (VGA in P...

hunuok · 04-14-2012

I haven't seen the issues you speak of but I suspect they were people using premix.I believe Koolance had a RMA process going to replace nozzles free of charge. From memory, I think it was a rubber O ring issue.Good news.Before disassembling for furt...

hunuok · 04-12-2012

@xeromist :Thanks for your reply.For the moment, I've managed to up voltages on PCH and GF200 (not sure if I chose correctly).I will test in the morning.As for QDCs, I also learnt the hard way of the importance of QDCs. LOL.I can disconnect CPU, GPUs...

hunuok · 04-12-2012

Have you connected the additional power connector for the PCIe lanes, and increased the amount of voltage to the lanes in BIOS?Yes to power connector. No to increase voltage.If I want to increase voltage, which setting in BIOS and how much?

hunuok · 04-12-2012

The PSU was purchased when I ordered the rest of my rig in late June 2011.Do you have any other ideas?I don't really want to disassemble my rig because it is a MAJOR task to drain, disassemble, reassemble components until I can figure out exactly whi...

hunuok · 04-12-2012

And your problem is gone as well?No, I don't think so. As mentioned, Surround, SLI etc works if I reboot after a few hours.I won't know until I start up tomorrow morning.But I'm not holding my breath.

User Statistics

User Activity

3rd GPU not recognized on cold start

Re: 3rd GPU not recognized on cold start

Re: 3rd GPU not recognized on cold start

Re: 3rd GPU not recognized on cold start

Re: 3rd GPU not recognized on cold start

Re: 3rd GPU not recognized on cold start