Hay,
I just got my PG348Q today. Powered it up could see the OSD. Then connected it up to my PC (1080 Ti) using the Display Port and the monitor is dead, no power nothing. However if I power off, disconnect the DP cable and then power back on, it fires up again.
I've tried 3 DP cables, I currently run a 4 monitor setup so had plenty of cables.
When ever I connect the DP cable, the monitor dies, no power LED nothing.
😞
Was looking forward to trying out the monitor as well.
I don't think I'm doing anything wrong, but if anyone has and ideas?
