Hi! So i have 2 AX11000 in AiMesh mode, i have the node connected by ethernet backhaul to the main one using the 2.5G port, because i have dual wan (2 ISP´s) in balance mode (1000 mbps + 600 mbps) so triying to get the most out of it via wireless, bu...
So I can't figure out what the heck this wire does (Circled in image). It runs behind the battery and seems to go into or behind the Left Speaker (Right in image). Does anyone know what its for, I haven't noticed any issues without it connected. I'm ...
Dear Sir/Mdm,As per above subject. I have updated my BIOS on my motherboard to version 3202. The suspected problem due to this update is my monitor display randomly unable to show any display during boot up, mostly with white error visual noise (Basi...
I hope you can help me determine the cause and fix for the LKD_0x141_Tdr:6_IMAGE_nvlddmkm.sys_Turing_3D Critical hardware Error as reported in the Reliability Monitor. This is a new build but using the same GPU as the prior build where the errors di...
Trying to update my BIOS from 1802 to 1903 using the internet from utility like I normally do but it doesn't seem to want to updated and says 1802 is up to date. Any idea why this isn't working now.
Forgive me if there is a recent post with the answers i am looking for, I have spent the last few days installing and uninstalling Drivers and Sonic Studio, Nahmic Drivers and restarts etc etcI have not been using my Desktop Build much recently as be...
I'm trying to download it where I usually do. It seems to be installed, but the panel itself is nowhere to be seen...Can someone give a link to an adequate installer ?Rog Strix B365-G Gaming*
Hi guis, sorry for my poor english, i classic studies, then my wonderful goes in red blue and yellow when it is off from the PC. I try to restore the defaul settings and change hdmi ccable. Tkns for any helps. Bye. Dp
HelloI left my Rog gl552vw switched off but still connected to the mains during a few weeks. When I wanted to turn it on, it could not start.I noticed that the light in front was on.Also, at the left of the pad, it was quite hot.I tried removing the ...
Hello,I am facing an issue of being unable to set up Windows 10 x64 (Clean Install) while using 2 x SATA SSDs in RAID 0. Windows is unable to detect the RAID drivers when i try to set it up. Its giving me this error "No signed device drivers were fou...
