How to change temperature trigger with Fan Xpert 2

[argerel]

Hi guys,

I have a watercooled Maximus Formula VI and I was wondering if it was possible to change the temperature trigger in Fan Xpert 2.
Here is my setup:
Pump is PWM and plugged in to CPU_FAN
Radiator 1's fans are all PWM and plugged in to CHA_FAN1
Radiator 2's fans are all PWM and plugged in to CHA_FAN2
Rear exhaust fan is 3-pin and plugged in to CHA_FAN3
Water temperature sensor is plugged into OPT_TEMP1
Case temperature is plugged into OPT_TEMP2

What I want to accomplish with Fan Xpert 2 is to change Radiator 1 and 2's fan speed depending on the water temperature information provided by OPT_TEMP1 (water temp) and to change the rear exhaust fan's speed with info from OPT_TEMP2 (the ambient case temp). Right now all fan speeds are being based on the CPU temperature, which in a watercooled system is kind of pointless. If any of you could walk me through how to change this in Fan Xpert 2 I would greatly appreciate it! Or if this is not possible to do with Fan Xpert but doable with some other software please let me know as well.

Thanks!

[argerel]

Anyone know how to set this up?

[Raja]

This is not doable AFAIK. You'll need to find some other solution.

[argerel]

Thanks for the reply Raja! That is unfortunate that this is unable to be done with Fan Xpert. I'll look into other solutions then.

[Zka17]

Hm... I think, argerel, what you need is a proper fan controller...

I can not figure out from your posts how many loops you have in your system... if it's a single loop, then having all fans controlled based on the CPU temp makes logic to me...