- last edited on by
ROGBot
1. cpu core ratio to 45 x targeting 4.5 Ghz .
2. vcore 1.270 v . on manual
3. Set min cache feq to 35 max cash Ratio to 42x .
4. cache voltage to 1.15v . manual
5. SVID - disabled .
6. eventual Input voltage to 1.79v hunter recommendation .
7. Asus multi core enhancement disable .
8. disable cpu spread spectrum .
Digi+ options:
9.Load Line Calibration to Level 6.
10.cpu power current 120%
some guys are telling me my cpu voltages are not idling this way and i should go adaptive,
but i see it dose idle
so what do you advise ?
2. vcore 1.270 v . on manual
3. Set min cache feq to 35 max cash Ratio to 42x .
4. cache voltage to 1.15v . manual
5. SVID - disabled .
6. eventual Input voltage to 1.79v hunter recommendation .
7. Asus multi core enhancement disable .
8. disable cpu spread spectrum .
Digi+ options:
9.Load Line Calibration to Level 6.
10.cpu power current 120%
some guys are telling me my cpu voltages are not idling this way and i should go adaptive,
but i see it dose idle
so what do you advise ?
yes but how do you explain the voltages idling in manual mode after disabling muti core enhancement
if i am not seeing this then the cpu is not idling then i may need to worry about it ?
if i am not seeing this then the cpu is not idling then i may need to worry about it ?
Praz wrote:
Hello
For the CPU voltage to decrease at idle you need to use either offset or adaptive voltage modes.
i still didnt know the scientific reason on why my cpu vcore is idle on manual when everyone told me it wont idle on manual ? is it the work of a good mother board ?
Praz wrote:
Hello
Manual voltage will stay at whatever you have set regardless of the load seen by the CPU or the clock speed. .
is that a bad thing ? i mean staying at what i have set it ? is idling necessary ?
HwinFO64 shows the cpu in idle status in the upper screens , no doubt about it . the sensor gose up and down at idle even at cpz
yes 0.5xx for idle is fine . its funny to say the vcore is not idling when all the sensors shows it is .
so its a must to set adaptive ? or its ok on manual too ? what are the adaptive values for me ?
core voltage 1.270 v
cash voltage 1.150 v
thanks . well the other thread was about cpuz not this topic .
btw disabling multi core enhancement with manual makes the vcore go to idle . test it
its ok if i stay on manual ? i herd that adaptive can over volt to 1.4 if the cpu is stressed . my idle temp is 25c and vcore also idle
Praz wrote:
Hello
Manual is fine if that is what you wish to use.
Praz what about vid voltage on manual ? it runs at 1.280 v all the time and i herd its bad for the cpu .
alright yeahh am an old school ocier lol , prescient all systems go ready to launch
