So I finally got to play with Offset mode per Raja's guide, although I'm on a Rampage board, rather than Maximus.I tried a basic setup, much as he described, and got that working okay at 3.8GHz. 1.2V (-ish) under load, with a nice drop to around 1V a...
I've been running a single cycle of benchmark test after each change I make and during those benchmark tests, I had no issue with the OpenCL test.Now that I've decided to stop at my current settings, I tried to run the Stress Test. (1 hour to start, ...
Hi everyone,I have an ASUS Maximus VII Hero with the 4790k processor, i've been working on my temps this weekend at stock and after reseating and setting the core voltage to 1.159 i get an average of high 60s to low 70s, which is a giant improvement ...
Create an account at HWBOT and join a TeamIf you aren't already register, here are the few steps to create an account at HWBOT:1. Go to hwbot.org website2. Click on the top left corner "Register"3. You can choose to register a new account or register...
I'll start by apologising if this is in the wrong section, first time posting here.Before I get into what is going on can I first ask what is the recommended/common 24/7 voltage of these processors as all the information I'm getting now is starting t...
Pc spec I5 4690kAsus Maximus 7 heroCustom water cooling with two radiatorI have clocked it to 4.7 ghz @ 1.372vNormal temperatures is below 30Prime 95 stress test 5min Temps are 72757469Can I keep this setting for everyday use?Will it shorthen my chip...
Hi allIm planning to replace current ram and increase ram capacity on Rampage 2 gene mobo. Currently I have 3 x 2gb 1600Mhz DDR3 and can do basic OC to 4.2GHz with turbo on. Mostly i use it at stock speed 3.2GHz( xeon x5672). Question is can i use si...
Recently, my brother just got his g501 about a month. He is getting BSOD of the video error. So after googling, the solution is to uninstall intel driver. So as he did that. Upon restart, he can't get into windows anymore, just getting a black screen...
Not a big issue, just a fraction of a second of flickering screen garbage when switching to fullscreen modes at low resolutions (like 800x600 and 640x480), then again when switching back to real resolutions (1920x1080 or higher).I still see this ever...
As you can see by my rig is the M7F and I have a vacant M2 slot up top.Will I see a massive difference getting an M2 PCIE compared to my SSD's in RAID 0?
