Rampage IV Extreme Debug Codes 67 when update bios 1101 ?

[nelly83]

Hello Friends, I just update bios to 1101 Bios, reboot the computer when the Debug Codes reported 67 (CPU DXE initialization is started). and shutdown. I rebooted the computer is the same. display is dark. please help me. (sorry for my english not very good)

[8_Pack]

I would try clearing the CMOS first. Then try with one stickl of RAM to see if it will post.

[HiVizMan]

Please flash to 1102 it is on the ASUS support page.

🙂

[roadczar]

HiVizMan wrote:
Please flash to 1102 it is on the ASUS support page.

🙂

Not seeing it...

[nelly83]

Hello friends, I tried clearing the CMOS first. situation has not improved
http://www.youtube.com/watch?v=IjeliMkcO2s&feature=youtu.be

[Shamino]

remove all 4 sticks of your rams and reinsert any one stick into any one of the red slots

[nelly83]

i remove all 4 sticks of your rams and reinsert any one stick into any one of the red slots , and Rampage IV Extreme Debug Codes 69 ? help

[HiVizMan]

Easy fix.

Reset ---> toggle Slow bios from on to off (or from off to on) ---> Reboot.

If no go then
Reset ---> LN2 mode bridge to enable ----> toggle Slow bios from on to off (or from off to on) ---> Reboot.


At least that is what I found worked with my system last night and I saw it a lot trust me on that one. Then make sure you have tweak 1 enabled in the ram settings. Sorted and I did not get it again until when next I forgot to set it.

Cheers

[nelly83]

HiVizMan wrote:
Easy fix.

Reset ---> toggle Slow bios from on to off (or from off to on) ---> Reboot.

If no go then
Reset ---> LN2 mode bridge to enable ----> toggle Slow bios from on to off (or from off to on) ---> Reboot.


At least that is what I found worked with my system last night and I saw it a lot trust me on that one. Then make sure you have tweak 1 enabled in the ram settings. Sorted and I did not get it again until when next I forgot to set it.

Cheers

thank you so muck , situation has not improved, until I switched to bios 2, and I was able to be BIOS2, and copy BIOS2 to bios1. thank you very much.

[Shamino]

somethings up on the ram/cpu memory controller side for b7 or b9 stuck in memory training limbo land