Help
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Not fully powering down?

ReaperXero
Level 7

‎01-27-2012 11:55 PM - last edited on ‎03-06-2024 09:52 PM by Community Admin

Not sure if there's a setting I need to adjust, but it seems after I shut the system down my keyboard flickers seems the USB components may be partially powered. Anyway to turn this off, or is it a known issue?

Crosshair V
Labels:
0 Kudos
3,770 Views
7 REPLIES 7

HiVizMan
Level 40

‎01-28-2012 04:16 AM

Could you confirm which USB ports you are using for your mouse and keyboard.

And welcome to the forum 🙂
To help us help you - please provide as much information about your system and the problem as possible.
0 Kudos

ReaperXero
Level 7
In response to HiVizMan

‎01-28-2012 09:41 AM

HiVizMan wrote:
Could you confirm which USB ports you are using for your mouse and keyboard.

And welcome to the forum 🙂


Thanks!
Upper Blue one in the back. I did try all the USB ports to see if it was just the ports. My keyboard is a Logitech G15.
0 Kudos

oldbrave
Level 9

‎01-28-2012 10:49 AM

Go into the bios under "advanced" tab seclect On Board Devices Config and disable the USB3 Charging.
I think that may fix your problem.
Electronic Smoke Signals From my TechnoTeepee
ASUS Crosshair V Formula AM3+ 990FX, 1703 bios
AMD FX 8350 Vishera @ 5162Mhz [21x245] 1.546v 🙂
Water Cooled - Koolance EX2-1055, CPU 370 WB, Idle=22c Load=52c
32Gb G.Skill Sniper ddr3 1600 8G X 4 , 9-9-9-24 @ 1.55v
ASUS HD7970-DC2T-3GD5, Cat 13.5 beta 2, Dell U3011 @ 2560x1600
SanDisk Extreme 120Gb SSD SATA 6Gb, 250Gb SATA 6Gb, 1Tb SATA 6Gb x2
Win 7 Ultimate 64bit, Corsair Obsidian 800D, Corsair HX1000w PSU
0 Kudos

ReaperXero
Level 7
In response to oldbrave

‎01-29-2012 12:52 AM

oldbrave wrote:
Go into the bios under "advanced" tab seclect On Board Devices Config and disable the USB3 Charging.
I think that may fix your problem.


good find, But didn't work. I tried different USB ports. Everyone still seems to keep the board lit up. The Onscreen display is off, but I have a little USB light I connect to the board and it stays fully lit, not to mention the board has a subtle blink.
0 Kudos

oldbrave
Level 9

‎01-28-2012 10:50 AM

Go into the bios under "advanced" tab select On Board Devices Config and disable the USB3 Charging.
I think that may fix your problem.
Electronic Smoke Signals From my TechnoTeepee
ASUS Crosshair V Formula AM3+ 990FX, 1703 bios
AMD FX 8350 Vishera @ 5162Mhz [21x245] 1.546v 🙂
Water Cooled - Koolance EX2-1055, CPU 370 WB, Idle=22c Load=52c
32Gb G.Skill Sniper ddr3 1600 8G X 4 , 9-9-9-24 @ 1.55v
ASUS HD7970-DC2T-3GD5, Cat 13.5 beta 2, Dell U3011 @ 2560x1600
SanDisk Extreme 120Gb SSD SATA 6Gb, 250Gb SATA 6Gb, 1Tb SATA 6Gb x2
Win 7 Ultimate 64bit, Corsair Obsidian 800D, Corsair HX1000w PSU
0 Kudos

HiVizMan
Level 40

‎01-29-2012 05:13 AM

Just out of interest, this power on state is there even when you flash to an different BIOS and are running at fail safe defaults?
To help us help you - please provide as much information about your system and the problem as possible.
0 Kudos

DaemonCantor
Level 13

‎01-29-2012 06:48 AM

I went through my system and what I found is on the CH4F if I have Ai Charger installed the USB's (all) stay powered up. when uninstalled it the USB's powered down at shutdown. I don't know if it's the same with the CH5F but I wouldn't doubt it. I have an iPod Classic so I love the feature it keeps my iPod fully charged.
0 Kudos