Maximus VII Ranger No pitcure And error q-code 55.

[Spaitzo]

Have just received my brand new Ranger motherboard.
Installed as shown in the manual and perform my first start up.
No image displays on the screen, and q-code 55 displays the on the motherboard.

Does anyone have any experience whit this? And if so what is the solution to this.

[Spaitzo]

No I have not looked at that.
Will do the moment my PC has cooled down.

[HiVizMan]

Cheers mate, I find it easier to take those images from different angles. That allows me to see the pins in alignment much better.

[Spaitzo]

As you can see from the pictures, there are one in that is out of alignment.
So this has to be the problem.
Better get me a new MB. Crap.

[Spaitzo]

As you can see from the pictures, there are one in that is out of alignment.
So this has to be the problem.
Better get me a new MB. Crap.

[HiVizMan]

Nope you can fix that - very sharp knife or blade and a steady hand.

I use a needle sometimes when it is just one or two pins that are out of alignment. You must just remember to work slowly and carefully. The pins are springy and you need to move them in small steps.

[TeChNoMaN]

I have the same problem, they solved? I have the mother mounted outside the case, and pulls me error 55 in slot a_1, and not to do.