07-23-2013 09:23 AM - last edited on 03-05-2024 09:56 PM by ROGBot
10-22-2013 02:47 PM
11-29-2013 04:52 PM
11-30-2013 12:57 AM
Matt1987 wrote:
Hi can anyone give me some advice on a q-code 62 then 03 my pc just keeps rebooting with no display an the motherboard displays these two q-codes with the vga led light up as well any advice would be greatly appreciated
11-30-2013 08:39 PM
12-31-2013 09:13 AM
02-07-2014 03:22 PM
02-07-2014 04:58 PM
feistyhippo wrote:
I purchased the OC Controller for this board, hooked it up, and now my computer will not post speeds past 800mhz per core. Im running a 4770k. Bios shows same settings at 4200 I have disabled EIST and CPU C Disabled. What do I need to do to be able to use this controller. I corrected the issue by disconnecting the controller, resetting the bios, and reloading my OC Settings.
a2zgunther wrote:
I just finished setup of new Build and I am getting an Q code A2 previous it shows 64 and I think 99.
the Boot device by the 24 pin ATX power led is lit- I have a couple of SSD's but havent gotten to the point of putting in Win 7 in the DVD drive or anything yet- was expecting to get to a BIOS on the screen - HDMI from ASUS GTX760 card- tried the onboard HDMI too no difference no display.
So what is best procedure to troubleshoot as ASUS tech support not answerting phones - busy signal
THoughts not reallly sure what procedure below to try next or what Q codes really mean
A2 id IDE detect??
64 is CPU DXE init started??
99 is SUper intitialization
other keyboard led's lite work fans good etc
what should I try - what to attck this the right way. should I do ______ first
disconnect two SATA cables and retry
disconnect DVD sata cable retry
disconnect PCI-e graphics card retry
clear CMOS retry
02-10-2014 10:03 AM
Chino wrote:
Pop off the cover for the OC Panel. You should see two switches that are close together. The Pause switch and the Slow Mode. Make sure the Slow Mode switch is turned to off.
Disconnect all your USB devices.
03-28-2014 09:55 AM
04-15-2014 04:26 AM