Maximus VI extreme 2-way SLI

[bitman]

I'm getting ready to do a 2-way SLI set-up with 2 Asus GTX 770 water cooled cards. My Question is the manual and Asus say I should use slot 1 and slot B2 but the EK water block I'm buying from FrozenCPU uses the triple bridge to connect the 2 cards which means I must use slot 1 and slot 3 the 4th one down the red slot not the black 3B slot. I'm I going to run into any problems using this set-up and do I have to change any thing in the Bios? My first time doing a SLI build so I could us any help you all can give me Thanks Stevebit

[Myk_SilentShado]

You must use slots 1 and B2 for 2 way SLI and you should change the block order and get the dual bridge

[bitman]

The dual block that is available from EK doesn't have the right spacing for the maximus VI Extreme board that I can tell the dual block is for the V version of the board. I don't understand why Frozen is selling me the triple block then I guess I will have to call them again. what will happen if I use slot 1 and slot 3???

[Myk_SilentShado]

Hmm, well there should be an updated version for the VI Series boards, would you mind sharing links with me please of the dual and triple bridges?

[HiVizMan]

Go over to the EK shop and use the hardware configuration tool, you will see heaps of bridges that work with the M6E

[Myk_SilentShado]

HiVizMan wrote:
Go over to the EK shop and use the hardware configuration tool, you will see heaps of bridges that work with the M6E

There is also this option too 😛