M4E and some issues

[boton]

First post here....:D Yesterday i recieved my m4e...:D
But i have some issues...First of all, it cannot post with my properly working rams. They
are a 4gb kit supertalent 2133c8 with hypers chips.
With one dimm it posts fine, but with both dimms the debug led stops to 45.

The other issue, is that even extreme ov is enabled, it cannot post with over than 1.53 vcore.

Any idea?

[Praz]

Is this issue at stock settings or the rated 2133MHz speed? I have some Super Talent 2200MHz CAS8 rated sticks and the board boot fine with them. They will not do anywhere near their rated speed though. Seems the M4E does not like the PCB Super Talent uses.

[Retired]

is the memory on the qvl list?

[boton]

Yestrerday i ran some benches, with one stick of course, at 1088 7-8-7. The problem is with both sticks.

No, the memory isnt on the compability list.

[Retired]

Half the memory on the QVL is outdated or not made anymore. Asus needs to refresh that document on the web sit.

[Retired]

well I would get some different memory or RMA those that you already have

[boton]

No need to rma them...They working fine on x58/p55/am3...;)
If a new bios wont fix my problem, then i have to buy some new...:D

[boton]

Hi again, two more issues....:p
Firstly, which version of turbo evo is best for mive? Because the one that is included at ai suite pack ive donwload from asus site, it show the bckl freq as 4,2mhz...
The other and more important problem, is happening when every day i open the pc...It stacks at windows load bar and a blue screen appears with code "page fault in
non paged area". I have to flash the bios or set manually the vdram..then boots and all day working stable without problems.
The memories pass all stability tests. The only strange ive noticed, is the psu 3.3v that in bios it seems to be a little down at 3.050v-3.100v...