Rampage III Extreme and Intel Xeon W3520
Should this combo work? Do I need to update bios?
Forum Posts
Possible fan header issue? Corsair H80
Hey all,I installed my Corsair Hydro H80. Temps are awesome on my 4.0Ghz overclocked 1100t. Couple of times now I get the CPU FAN_0 message from (I assume) the AISUITE. A check of HWmonitor, and a look in the case window confirm this and I shut down ...
First PCI-E X16 works 1/8 times.
I'm prett sure that the first PCI-E slot is damaged since it only allows me to boot up once about ever eight times. Using the other slots it works flawlessly, but I shouldnt have to ignore the fact that my MOBO CHF5 is broken. Any ideas before I have...
C5F SB950 Port 3 works and fails in RAID mode
Okay, I've done some testing on my mobo... get ready for a lot of information.I've got a Crosshair V Formula, and I have a 120gb SSD as well as 4x1TB Seagate drives (not WD, because they disable raid features on consumer drives- BAD WD! BAD!). I've a...
Ram OC
So i have The Crosshair V Formula MB and i got G.SKILL Ripjaws X Series 8GB (2 x 4GB) 240-Pin DDR3 SDRAM DDR3 2133 (PC3 17000) Desktop Memory Model F3-17000CL11D-8GBXL. I was wanting to overclock it so i went into the bios and changed it and and it ...
Maximus Extreme x38 Thermistors
Hi, I have a Maximus Extreme X38 motherboard in my PC, I have installed the thermistors to areas of the board I wish to monitors as well as connecting the other ends to the MB itself.The problem is, in the BIOS, the OPT 1 OPT2 and OPT3 temperature se...
cant start normally by start button..only by GO button..pls help me
somebody pls help..i can only start the windows by GObutton, not by usual way, the start button..Crosshair V FormulaPhenom II X4 955EVGA superclock cpu cooler4GB G.skill ripjawGamma 600W PSUCM Storm SniperMSI R6970WD 500GB Caviar BlueWindows 7 Ultima...
CPU Temps / Cores Temps question
Hey guys,So I've been monitoring my system for a bit since I got my new setup finally stable.However I have a few questions.For the CPU, what is more important? Total CPU temps or Core temps? I have an FX 8120.This is what it shows for me idle right ...
Load Line Calibration
Hi,I have some questions if anyone can help with regard to LLC.Q1: I'm trying to get my 2600k stable at 1.38v on my Maximus IV Extreme...I seem to be able to get better stability with vCore LLC set at 75% than at the recommended 50% for a 4.6Mhz OC.Q...
4 ram modules vs 2
Hi.. I cant really decide what ram to pick, I want tight timings for my 1100T but the only right timings I can find are 2x2GB modules, the 2x4 has slower timings..I thought about the Corsair XMS3 7-8-7-20 and run them at 1T. So here comes my question...
