Other Motherboards
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Am I being a idiot

Hi guys,Currently building a x79 rampage 4 formula, 3930k 16gb ram,Bios is showing 8GB only? I don't want to reseat the memory as I don't have any thermal paste alcohol removal... and I have the Phantek which is to big to pull the memory out while se...

m3tz by Level 7
  • 10 replies
  • 0 kudos

GPU TweakIt not launching

I am unable to get GPU TweakIt to launch from a remote connect computer. I have installed ASUS ROG Connect Plus V1.00.14 to my RIVE PC and the ASUS ROG Connect V1.06.03 on my laptop. My PC is running Windows 7 Ultimate while my laptop has Windows 7 H...

UserX by Level 9
  • 10 replies
  • 0 kudos

RIVE - Install Windows 7 from a thumb drive on a RAID0

How to Install Windows 7 on a RIVE from a thumb drive on two SSD’s in a RAID0 arrayWhat I assume•You have a common knowledge of Windows and it's file system•The ability to obtain an ISO image of Windows 7•You are installing the X64 flavor of Windows ...

UserX by Level 9
  • 2 replies
  • 0 kudos

R4E: Tired of cold boot failures

I'm just sick of the system constantly not being able to power up after being off for a few hours. The config consists of an R4E, i7 3960X, 32GB RAM DDR3-1600 (same thing with 16GB only), 2x GTX 580, Silverstone ST1500 PSU, blah blah blah... Almost e...

Fake Boot Rampage IV Extreme

Hello Friends, I wanted to point out that the motherboard has a problem of fake boot, when you turn off the system completely and turn on again. Please resolve in the next BIOS. thanksBIOS 1101

Red_Jhon by Level 10
  • 9 replies
  • 0 kudos

Thermal cables?

Was not included when i purchased my rampage/formula x79Had to steel some from my other mainboard..why?, I mean, a few cable's, whats the deal..:cool::cool::cool:

Retired by Not applicable
  • 6 replies
  • 0 kudos

Ram speed?

At 4.8ghz how should i run my memory speed? my motherboard default the memory speed to 1333mhz my kit is CORSAIR Vengeance 16GB (4 x 4GB) 240-Pin DDR3 SDRAM DDR3 1866mhz?? please let me know.at 1333mhz which voltage would be batter at 1.50v or 1.65v?

Incorrect DRAM speed showing in Windows

So I finally got my build done and have finished installing all of my apps. I haven't started OCing yet but when I went to look at CPU-Z and AIDA64 my RAM speed showed up as 1066. The memory tab for CPU-Z is not even populated aside from the amount o...

Maximus IV GENE-Z/GEN3 hangs on debug 98 (resolved)

Self resolved, but thought I'd pass along my issue.I've got a new build that was error free until today.After about a week, the new symptom is that it's hanging in POST on debug code 98 (console input devices connect) for over 2 1/2 minutes. I cannot...

Retired by Not applicable
  • 1 replies
  • 0 kudos