Other Motherboards
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

CH5F Probmel... Again

Yep, problems with it again. So, sometimes when I wake my PC from sleep, I get a red warning on the right side of my screen saying my motherboard is at a critical temperature of 128c+I check AIS2 right away, and temps are normal. Not sure why this ha...

Jok3r by Level 7
  • 16889 Views
  • 24 replies
  • 0 kudos

Bought an 8150, when does Ivy Bridge come out again?!

So, I bought one to see if they were being overly bashed or if they are really as terrible as said.Results:PROS:Performance wise it is actually noticeably more responsive and quicker to use the PC than with the Phenom 2 installed and clocked at 4.4gh...

Problem with Rampage IV extreme and Radeon HD 7970

Hey all,I have to two systems, each with same Sapphire HD 7970 graphics card, same OS, same drivers. My system with Rampage IV extreme has i7 hexcore 3960x. Other system with P8Z68-v Pro/Gen3 LGA1155 motherboard with quadcore i7 2600k . On paper the ...

devguy by Level 7
  • 5321 Views
  • 5 replies
  • 0 kudos

g-skill ..what can ya say but good

ok so i got that 1600 1.35v mem ..off g-skill and have been overclocking well ish .got to the 4.2 but had to go the easy way .. 20x multi .. the 1.35v will not go over 217 fsb so i asked g-skill in a e-mail if i could swap it for some 1866 or 2133 .....

C5F Overclocking

So basically I have started to overclock my setup with my new water cooling rig. I have it up to 4.0ghz just tweaking the multiplier and bus speed. I know I can get it higher, my temps under load are around 50c and at idle are 38c. My question is, wh...

EDieter by Level 7
  • 3155 Views
  • 4 replies
  • 0 kudos

Some doubts about R4E and SB-E

Gentlemen,My name is Federico, i'm from Argentina. Here, hardware is very expensive. It's normal if you enter into some e-shops and someone is trying to get from you the DOUBLE that an US reseller does.Well, the fact is that i bought a great rig, wit...

Fedoteh by Level 7
  • 6052 Views
  • 7 replies
  • 0 kudos

Rampage IV Extreme, AHCI drivers, and installing on XP HELP!

Hello, I am installing WinXP pro 64bitI want to install AHCI drivers so i can leave my Bios SATA Mode on AHCII downloaded and copied the Intel RST Raid/SCSI Drivers From ASUS Rampage IV extreme Downloads section.I then extracted the 64bit drivers to ...

jblanc03 by Level 7
  • 15637 Views
  • 15 replies
  • 0 kudos

Desktop Memory

What memory will work with the Crosshair V Formula. I have memory 4gb and running 2133mhz but i wood like two upgrade my two 16gb iam looking find out what memory will work best with Crosshair V Formula memory i posted thank you four any can help wit...

Stuck with an issue

Following a guide a found from here I did a OC to 4.9 and seemed to be fine but I pushed it to 5 and all she wrote. It was stuck on an error code 79. Sent the board back to ASUS they sent back the same board looks like all they did was reset it not s...

Ron by Level 7
  • 2708 Views
  • 2 replies
  • 0 kudos