Hi guys,Having some more problems with my Rampage IV Gene motherboard (again). My PC will not respond after having gone into hibernate mode (so I have to restart it). I think it might just be a USB issue though.Any help is much appreciated. Thanks.Sy...
I am using a Maximus V Gene motherboard.It cannot seem to find any hard drives that are plugged into the ASMedia ports. My plan was to boot to a small SSD on the red Intel port, than run a RAID1 array on the two ASMedia ports, but I cannot see these...
Hi!I am new, and my english is a little bit rusty to:oSo my problem is this:Evry time I boot pc (no matter if i just restart or power on) i get this massage. And when i get this, bios set my cpu to defoult setigs. So I downclocked my cpu, fash bios t...
Hello, I recently got a Rampage III Black Edition motherboard. On the motherboard it says built in X-Fi2 SupremeFX. However when i install the Creative software, the device cannot be found. Apparently I have realtek onboard audio on my motherboard an...
Ok so i have the system up an running, no problems, originally my RAM was only running at 1333, but after having read some posts on here i figured out how to change it using the 'XMP' profile, and now i ahve 12gb running at 2133 perfectHowever i hav...
In the overclocking guide it mentions that I should make a VREFCA adjustment to compensate for the rounding errors in Prime95 of 50.5% of VDDQ? What is VDDQ? - I do not have a voltage setting in the 1401 bios that says VDDQ. I also understand that t...
Hi,Can anyone please explain what the deal is with the Intel vs Asmedia Sata 6g controllers? This is driving me completely nuts.OK, I have 2 SSD's (Crucial m4). I want one connected to the Intel controller, and one to the Asmedia controller. I want t...
I just installed my second Crosshair V Formula board and have a few problems. 1: I am getting a CPU Fan error when booting....I have no CPU fan as I am water cooled, what do I do?2: I have 16gig of DDR3 1600 that was working perfect on my other Cr...
At GEN 3 Safe Mode hangs at pnp-final stage and I have to force shutdown. Restart and I get the overclocking failed press F1. At GEN 2 I can boot into Safe Mode, but, when I hit restart I get a BSOD-iastorA.sys error. If I boot into Safe Mode after u...
I'm stuck at 4.93 (http://valid.canardpc.com/show_oc.php?id=2411457) and I want to at least reach 5ghz. look at the cpu-z to see what Internals I have. Oh, I am using a corsair h80 btw.Now for the bios. I'm using the 1402 bios. I loaded the extreme o...
