Other Motherboards
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Rampage IV Extreme - Tri-SLI GTX 680 + X-Fi

Is it possible to make this configuration? I think the only way to do this, is to install X-Fi into bottom slot (PCIe 3.0 x8_4 slot), but I'm not sure that X-Fi will work that way.

booya by Level 7
  • 5549 Views
  • 8 replies
  • 0 kudos

Maximus Gene V

Hello, I've recently built my new computer using the Asus Maximus Gene V motherboard and I have encountered a weird problem. Every time I turn my computer on, there's no beep and display on the screen. I also get the debug code B2 or 62 from the mot...

MVG RAID 1 slow read issue

Hi guys,I'm trying to configure RAID 1 array using Intel RST with two WD10EADS drives (green, but fixed for TLER and LCC bug).After setting up RAID 1 array I experience slow read speeds around 50-60MB/s. Write speed is fine @c.a. 85 MB/s.Setup:Asus M...

ASUS Rampage Formula IV unstable

Hello,yesterday I got my new ASUS Rampage Formula IV Mainbaord, put my Intel i7-3960X on it and booted my PC.I started by loading "Optimized BIOS Defaults" and only disabled Speedstep and C-States.All other settings were left on default.After that, I...

Demian by Level 7
  • 5272 Views
  • 7 replies
  • 0 kudos

Gene V issue, no display, code 20, Second board

Hi I posted previously about issues I was having with my first Maximum Gene V motherboard, the replacement finally arrived, connected everything, tried to boot, no display, tried a couple of monitors, two sets of wires, the onboard HDMI port, reset C...

help! unable to install windows!

i juat got myself a rive with 3930k. am running raid0 with a highpoint rocketraid 2720sgl but i have issue installing windows.upon loading the drivers needed for my raid card, i will have this error that windows is not able to format my drive. can an...

jaemon by Level 7
  • 12779 Views
  • 24 replies
  • 0 kudos

Red LEDs flashing during boot

Hello AllOn my Formula V Crosshair 990X my Q LED's (page 2-17 on the manual) are flashing on and off one at a time and then turning off while the is sustained and running.I had two failure to boots today. One was after I first got home so I cut the p...

Ridir by Level 7
  • 4000 Views
  • 6 replies
  • 0 kudos

Bios flashback on Maximus iv gen-z gen3

Hi people.I bought the maximus genz/gen3 last year and have enjoyed everything about it up untill i upgraded the bios to 3203(from 0402) and now like every one else i have all the bugs and the board is alot less stable Ive been looking through alot ...

scoobie by Level 7
  • 3980 Views
  • 3 replies
  • 0 kudos

Z77 Sabertooth - Fan Screw Size

I recently had to RMA my Z77 board, but I stupidly left both fans mounted. When I got my new board, I got a new pair of fans but not a new set a screws.Can anyone tell me the measurements for the "short fan screws" and the "long fan screws"?If possib...