Other Motherboards
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Connectors problem with FORMULA MAXIMUS V

Hello there!I have a question about my FORMULA MAXIMUS V , to the northebridge there are 2 female conectors for power supply one with 8 pins (female )and the other with 4 pins( female). I connect the 8 pin con. but with the other what can I do? If I...

Is this over clock real?!

ok guys so im working on getting my 3770k up to 4.5 ghz from 4.3. im in offset mode. i was setting mult to 4.3 and leaving offset to manual. at that setting the cpu was getting about 1.23 volts on system start up but under load it was drooping to aro...

jsarver by Level 11
  • 15397 Views
  • 27 replies
  • 0 kudos

R4F / bios 3602

Hello guys, I've updated the latest BIOS on my Rampage IV Formula via ALL SUITE II correctly,but I don't understand why my processor remains to 3.800Mhz all the time.I've applied only X.M.P. Profile and saved the config.Before all of this , with prev...

Adouken by Level 7
  • 5118 Views
  • 8 replies
  • 0 kudos

Seems I Have A Poor Chip

I followed Chino's overclocking guide and successfully booted at 4.7 with 1.35 Vcore. Highest temps during stress testing were 90. My problem is if I drop the voltage at all from 1.35 then I BSOD after seconds of Prime95. I realize I just may have a ...

bmw477 by Level 8
  • 12570 Views
  • 20 replies
  • 0 kudos

Voltage Question

As I was following Chino's Fomula overclock guide I noticed one thing that doesnt quite make sense to me. I turned down my voltage via CPU Voltage section (set on manual) to 1.28, yet when Prime95 is ran the voltage goes up to 1.30-1.31 on the CPU-Z ...

Get ready for 12C/24T/30MB XEON yet ?

Xeon EN/EP E5-xxxx v2 seriesWondered why Intel is not exactly rushing with the new Xeon (or, for that matter, any Socket 2011 CPU) product announcements? Well, in the absence of any competition at present, the push to accelerate all the expensive ...

R4E3960X by Level 10
  • 3287 Views
  • 2 replies
  • 0 kudos

Gamefirst II Software on MVE?

Can the Gamefirst II software be used with the Maximus V Extreme or is it specifically for the Formula?(May be a dumb question but I don't see the Gamefirst II download on the Asus Support site for the MVE.)

bmw477 by Level 8
  • 4879 Views
  • 2 replies
  • 0 kudos

About To RMA Motherboard. Any Advice?

Besides taking thorough photos of my board? One of the traces below the PCIe slot 2 is burned. It's not black or anything, just slightly melted. The system simply refused to detect the graphics card a few days ago. I don't overclock and I've been usi...

Snaptrap by Level 10
  • 11818 Views
  • 14 replies
  • 7 kudos