Other Motherboards
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

R3E + Vengence Pro Memory

So... I'm a little behind on upgrading to the latest and greatest CPU/Motherboard - I'm running my R3E watercooled and overclocked and don't really see the need. I was curious though to know if I would have any issues putting in 24GB of Vengeance® Pr...

Gawlron by Level 7
  • 2815 Views
  • 3 replies
  • 0 kudos

Asus Maximus V Extreme case

Hello guys,This will be my very first post on these boards so please bare with me :).I've been collecting some new hardware recently to start my 3rd game pc project only this time I'm going to have a 3-way Sli setup instead of a single GPU. My quest...

Maximus VI Hero -Help needed

Ok, I am not sure if my motherboard is fault free. Anyhow, my setup is about a day old, and for the most part it works fine. (MVIH + 4670k). My chip runs @ 4 ghz with 1.21v stable atm and temps are fine, it refuses to go any higher even with insane a...

Rookie by Level 7
  • 5049 Views
  • 5 replies
  • 0 kudos

Maximus VI Extreme Beats The 2V Cap On Intel Haswell FIVR

http://rog.asus.com/244742013/maximus-vi/maximus-vi-extreme-beats-the-2v-cap-on-intel-haswell-fivr/In relation to the introduction to the FIVR yesterday, this article details how only the Maximus VI Extreme can exceed the 2V limit set by Intel. Extre...

X-ROG by Level 15
  • 2039 Views
  • 0 replies
  • 0 kudos

Force Enable PCIe 3.0 on your Rampage IV Extreme

If your motherboard, CPU and graphics cards all support PCIe 3.0 then shouldn't everything run at PCIe 3.0 speeds? The answer is no, by default your motherboard and graphics cards will only run at PCIe 2.0 speeds which significantly hinders system an...

OSX 10.8.4 Installation

Testing out OSX 10.8.4 direct install went in smoothly on a new 256GB SSD on R4E, I'm posting from the Same System... Trim is Enabled as well.Sleep is working OOB, no DSDT.

Asus Gene V HDD Whea Reset error?

Hey guys, I have a Gene V and I am using a single HDD in ACHI mode, however in the windows even log I see this pop up every now and then Reset to device, \Device\RaidPort1, was issued. Event ID 129I tried changing power options to high powe and that...