appropriate case fan

[DAS-haMMer]

Hi all

What kind of Case fan should I get for the MVG so that I can control its speed with AIsuite.
i,e variability . the mobo have 4pin only , and finding if a fan has 4 wires is a bitch.
I been looking at Corsair's SP120 but it ain't clear .

I want the Corsair for the red ring , and possibility of strength as I plan on just 1 back case fan.

Thx

[DAS-haMMer]

How about this ?


nobody uses a fully controlled Case Fan hmmm :confused:

[SUKARA]

I think it can be, by your own choice

[DAS-haMMer]

SUKARA@ASUS wrote:
I think it can be, by your own choice

Its meant to be joke , for fan .. soz .. fun :cool:


I'm still looking for a 4pin Case Fan ?

[TenBlade]

DAS-haMMer wrote:
Hi all

What kind of Case fan should I get for the MVG so that I can control its speed with AIsuite.
i,e variability . the mobo have 4pin only , and finding if a fan has 4 wires is a bitch.
I been looking at Corsair's SP120 but it ain't clear .

I want the Corsair for the red ring , and possibility of strength as I plan on just 1 back case fan.

Thx

Why are you going with only one case fan? I think you would have to screw three case fans together to get enough pull. Or if there is a single fan that would do the job, I think it would be quite noisy. And you need not fiddle with AIsuite´s Fan Controller very much, a single fan would have to run max rpm.
But, why again, only one fan? What case you got?

[DAS-haMMer]

TenBlade wrote:
Why are you going with only one case fan? I think you would have to screw three case fans together to get enough pull. Or if there is a single fan that would do the job, I think it would be quite noisy. And you need not fiddle with AIsuite´s Fan Controller very much, a single fan would have to run max rpm.
But, why again, only one fan? What case you got?

I have Antec Sonata 1 , with homebuilt watercooling. I tried 2 fans but there is no need !
what matters is negative air pressure to draw cooler air in . So I have been looking at Corsair SP120 .. but I don't see it has 4pin-wires .

Your GTX680 is a room heater , but my Zotac GTX 660Ti is one of the low power consumer of these cards .

I am modding the case now , and I am considering adding a bottom indrawing fan , small one though.

Still, my issue is buying fully controlled fan for the 4-pin the MVG has, instead of the original Voltage controlled original 12cm fan .

thanks

[DAS-haMMer]

TenBlade wrote:
Why are you going with only one case fan? I think you would have to screw three case fans together to get enough pull. Or if there is a single fan that would do the job, I think it would be quite noisy. And you need not fiddle with AIsuite´s Fan Controller very much, a single fan would have to run max rpm.
But, why again, only one fan? What case you got?

I have Antec Sonata 1 , with homebuilt watercooling. I tried 2 fans but there is no need !
what matters is negative air pressure to draw cooler air in . So I have been looking at Corsair SP120 .. but I don't see it has 4pin-wires .

Your GTX680 is a room heater , but my Zotac GTX 660Ti is one of the low power consumer of these cards .

I am modding the case now , and I am considering adding a bottom indrawing fan , small one though.

Still, my issue is buying fully controlled fan for the 4-pin the MVG has, instead of the original Voltage controlled original 12cm fan .

thanks