980 Matrix ln2 bios help

[ciccoman]

Hi guys.

Can i enable ln2 bios with two Matrix in sli?

Sorry for my english 

[Menthol]

Ciao ciccoman
yes of course you can

[ciccoman]

Thanks for the reply.

I tried to short the pad on the back with a thin copper wire, but nothing has changed ...

There is any other thing to do than move the switch in "ln2" position?

[Chino]

Make sure you've shorted them properly. Then all you have to do is push the switch to the LN2 position.

[ciccoman]

Yes, i've shorted them properly (the external pad only... ) and i've push the switch to the LN2 position... but I used a copper wire attached with adhesive tape, so as not to void the warranty.

I think eventually I should solder... 😛

[Chino]

ciccoman wrote:
Yes, i've shorted them properly (the external pad only... ) and i've push the switch to the LN2 position... but I used a copper wire attached with adhesive tape, so as not to void the warranty.

I think eventually I should solder... 😛

Which program are you using to overclock your GPU?

[ciccoman]

Menthol wrote:
Shorting or soldering the points together allows more control to the card using ASUS GPU Tweak, you may need a specific version for your card, and be very careful, especially if you have not installed water cooling as it will allow for higher voltage. At least it has on past models I have owned

Yes, i know 😉

Chino wrote:
Which program are you using to overclock your GPU?

I use GPU Tweak 2.8 .

At this point, I suppose that the problem is the method of connection points. Probably the wire does not touch the pads properly.

[Chino]

ciccoman wrote:

At this point, I suppose that the problem is the method of connection points. Probably the wire does not touch the pads properly.

That sounds like a possibility.

[Menthol]

Shorting or soldering the points together allows more control to the card using ASUS GPU Tweak, you may need a specific version for your card, and be very careful, especially if you have not installed water cooling as it will allow for higher voltage. At least it has on past models I have owned

[IronAge]

I got LN2 Mode enabled ... GPU Tweak latest (2.8.2.0) ... still it won't let me bypass 1.212 VDDC limit - any idea ?