Hello everyone,
I just installed a brand‑new RTX 5060 on my system with the following specs:
Here is the issue I’m experiencing:
I fully uninstalled my old GPU driver (RX 580) and installed the RTX 5060. At first, the system did not display anything.
After some trial and error, I went into the BIOS and set CSM = On. Then the GPU was recognized, I installed the drivers, and gaming performance worked fine.
When I later set CSM = Off, the motherboard VGA LED turned white (not recognizing the GPU), but Windows still booted and the driver detected the RTX 5060. However, I could no longer access the BIOS.
After rebooting, Windows would load normally (desktop shows), but the VGA LED remained white.
To access the BIOS again, I have to reinstall the RX 580, enter BIOS, set CSM back to On, and then reinstall the RTX 5060 to use it temporarily.
Has anyone experienced this issue? Is there a fix to allow the RTX 5060 to work with CSM Off and access BIOS normally?
Thank you for any advice!
