cancel
Showing results for 
Search instead for 
Did you mean: 

ROG STRIX Z690-I GAMING WIFI NVME PCIE RAID 2x SN850

mark0409mr01
Level 7
Hi,

I have recently built a system using ROG STRIX Z690-I GAMING WIFI motherboard along with 2x SN850 WD Black PCI-E SSD's.

I was hoping to set these up in a RAID0 config, I have followed the steps correctly outlined on the following (from page 10)

https://dlcdnets.asus.com/pub/ASUS/mb/13MANUAL/RAID_Configuration_Guide_V2-EN.pdf

However it appears that M.2_2 keeps dropping out and Windows is unable to boot after I have setup the array and followed the steps for driver installation etc. Additionally I have also noticed that only one of the SN850's show up during POST. I have verified that both drives work individually and I've had no issues installing windows to each drive on it's own...

Attached some pictures showing the issue

92190
92191
92192
1,892 Views
1 REPLY 1

mark0409mr01
Level 7
I just found another thread which describes almost exactly the same problem I’m having

*https://rog.asus.com/forum/showthread.php?127294-ASUS-ROG-STRIX-Z690-I-GAMING-WIFI-secondary-NVME-(M...

It would appear this is then a known issue with this board, has this been replicated by ASUS support? And if so is a fix incoming?*