Thanks for the update man! I will post in a week when I am done building. I will start with vanilla XMP 1 Ãƒâ€š*at 5600, run a few stability tests and start tweaking things around.Ãƒâ€š*
After the weekend of a lot of gaming, I think I'm going to have to dial this down again. I'm not 100% sure this is related, but my game crashed (various errors, DX11 errors) about a half dozen times. Hard to know if that's related to the RAM or if it's the game, but the game didn't seem to crash that much before. I also got one BSOD. Again, one isn't enough to know for sure if it's related. It's certainly less than I had at 5867, but I'd prefer zero, so I'll try some more and see. Hopefully the new year will bring a new BIOS version to support this fully.
I have G.Skill 5600mhz CL36. XMP I and II crashes while gaming, but stock speeds @4800C40 works fine.
Latest BIOS and so on. Kind of frustating as I was planning to try OC to 6000C32 later on.
Not sure if this is really just RAM related, or some Win 11 error as well.
Anybody has an issue while running Win 10?
something else is happening here. I have two sticks stable at 6000 XMP1 C36 (stock timings and speed). Perhaps bad RAM?Ãƒâ€š*
I have the same issue with the same board and RAM sticks.
4xDIMMs of GSkill 6000 CL36 2x (2x16GB)
Running only 2 DIMMs I can get XMP I to work but II gets errors on Memtest. When I run 4 DIMMs, XMP I & II get no boot.
Curious to see what others are doing to get this to work even close to 6000MHz.
Silent Scone@ROG wrote:
You won't. 4X16 6K isn't possible.
If you're combining memory kits, which isn't recommended, you'll have to tune manually. Aim for between 4400-4800
Easiest approach is a combination of VDD/VDDQ/VCCSA/MCVDD
So I was able to run a successful MemTest at 5000MHz with my 16GBx4. I need to double check the latency but I think it was CL42. I can double check this weekend. I had set everything to auto except for the speed.
On a side note, I have to check my board's S/N to make sure it is not one of the affected batches. Ugh, it would be a nightmare to have to swap out the board!