Hardware & Build Advice
Hardware & Build Advice
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

STRIX B350-F, Power to hobo but no boot?

I have a Strix B350-f and it was running fine with a Ryzen no issues. Power went out for 10 mins yesterday and now power button on case won't boot the machine.*I have tried resetting CMOS, even tried jump starting by shorting the power pins (where po...

jancy by Level 7
  • 3032 Views
  • 1 replies
  • 0 kudos

Memory Speed Issue Crosshair 7 Hero, Ryzen 3000

Hello Asus Forums, (hope this is the right discussion thread!)So I know you've probably read the title and know where it's going. I didn't do the proper research before buying the C7H and didn't check the memory compatibility list. However, I've been...

Memory speed ???

Hi All,First ASUS Board.ROG Strix B450-FRyzen 2700XSamsung Evo 970 M2 1TB, Crucial SSD 1 TB storageCrucial Ballistix Sport LT 3200 MHz DDR4 32GBXFX Radeon RX580 8GBBoard does not see memory in BIOS as 3200 It sees the RAM as DDR2400 with voltage at 1...

Motherboard / Ryujin 360 issues

Hello, I recently built a new rig using a TUF GAMING X570-PLUS motherboard and a Ryujin 360 cooler. I have the rear case fan in CHA_FAN1, Ryujin pump in the AIO_Pump port and the 3 fans on the radiator are plugged into the SATA cable that connects b...

S40G not compatible GL553VD..?

I just bought Spectrix S40G RGB M.2 2280 PCIe Gen3x4 SSD 512Gb for ROG Strix GL553VD.But not detected after installation.IS S40G unsuitable for my laptop?Thank you and give me a solution

NVlink bridge

Hi guysI have strix 2080 ti and dual 2080 ti can i put them in sli with nvlink bridge...does it works or not?Thx in advance

Dalibor by Level 7
  • 1395 Views
  • 1 replies
  • 0 kudos

Z390A Dead After RAM Upgrade!

I fear my motherboard died. I had two sticks of Micron Ballistix RAM for 32GB total. Worked fine since December.Today I installed a matched set of the same part number, but four sticks for 64GB.System won't POST. Motherboard lights eventually turn wh...

Basspig by Level 7
  • 2204 Views
  • 8 replies
  • 0 kudos

Help Creative Labs fix the "AE" series Bugs

Hi guys,If anyone here has an AE series Sound Blaster card and has issues, then please continue.I'm not paid by Creative labs, I'm an audio enthusiast who wants my issues resolved. Getting that out of the way, I was hoping if anyone here with a Creat...

Network Adapter and USB disconnect

I am having an issue that pops up during three specific situations. Ether editing photos in Luminar , video in Filmora 9 or browsing certain sites. e.g. Nexus Mod and even this site some of the time.My network adapter and front end USB disconnect. No...