06-24-2022 03:38 PM
07-01-2022 10:51 AM
Tried with them 1 foot away. It only set up a 2.4g backhaul, which is said was weak, and would not reconnect when the 16000 rebooted. Had to revert back to repeater.
07-01-2022 06:48 PM
As I watched in the beginning the backhaul would jump from ethernet <-> 5 Ghz <-> 6 GHz as well as vary connecting to other nodes. (Not ideal setup. Eventually it settled with 1 Gbps wired backhaul, I had accidentally connected to the blue WAN ethernet port on the back of the AXE11000 which is limited to 1 Gbps. Once I tried the 2.5 Gbps port it imediately showed 2.5 Gbps. I did not need to reboot or reset it...)
The only thing I could suggest trying while waiting to ship it back is hard reset everyone, then start with the AXE16000 setup, then go down from highest spec to lowest and try again maybe with SmartConnect ON this time. (Keep in mind most ASUS routers allow Binding for your IoTs/security cams. I'm not even sure the Lyra Voice wasn't just defective and that's why it didn't support binding. There was no 2.4 GHz radio signal). Not sure about these but I'd keep AX mode ON, enable 160 MHz, and set channels Auto. If it doesn't settle down eventually (I think mine took a day) then send it back....
09-24-2022 05:25 AM
09-24-2022 07:20 AM
09-24-2022 07:40 AM
Instructions for setup say to set up close to each other, then move them further away (in the middle between main router and dead zone). My nodes are in different rooms and/or on different floors...
Have you tried the "Optimization" button?
09-25-2022 07:58 AM
09-25-2022 12:01 PM
I do have an AXE16000 and AXE11000. Let me pull the Ethernet connection to the AXE11000 and see what happens...
09-26-2022 06:19 AM
09-27-2022 06:13 PM
I did factory resets on both units. I am Worried that if ii is a bios issue then an RMA will not fix it, so I am on the fence.Ã‚*
06-26-2022 09:08 AM