Hi, have you resolved ?
After several test this is what I could see to operate the 160 Mhz band:
Disconnect all peripherals from the 5Ghz-2 network (forget the network)
Select ax only, channel 100 and 160 MHz only, click apply
Wait 15-20 min
The 5Ghz-2 network will appear and after entering the wifi key you will be connected in 160Mhz.
Thank you!!! This worked for me too!
Both bands are operating at 160mhz for me now on this firmware.
for 5ghz-2 I had to set the channel manually to 100 for it to work.
Working on both GT-AX1100 and RT-AX92u
chris k wrote:
Did you you anything special to get 160 to work on ax92u? I have 160 enabled but still only getting 80. I've tried to disable wmm as was suggested for the ax11000 but the disable option is not longer there on the ax92u with the latest firmware.
For my AX92U, I set the 5Ghz-2 band to AX Mode only, checked 160Mhz, selected 160Mhz only, and set the control channel to 100. Applied the settings, and about 45 seconds later it was working.
chris k wrote:
That did it. Thanks!
Ok, I'm not sure I'm clear what I need to do, I got the AX11000 now and added to my setup as the main AP. I can't manage the AX92U directly, if I try to login to the web interface it redirects me to the interface of the AX11000 as I have everything in AI MESH.
My AX11000 will only let me set 160 enabled on 5hz-1, but the AX92u I think only supports 160mhz on 5Ghz-2?
What am I missing here? Sorry guys, I know this thread is pretty clear, but I can't get this to work at 160. (By get this to work, I would like the backhaul connection between the ax11000 and the ax92u's to be using 160 channell bandwidth to each other.)
Also, I don't have an option for channell 124 oddly!
On the AX1100, try not using 160Mhz on 5Ghz-1. Apply the settings. Upon reboot, try the instructions I posted for 5Ghz-2, and apply. That should fix it.
ok no matter what I do, I don't get the 160mhz on 5Ghz-2 checkbox. I'm going to try to do a factory reset on the main router (AX11000) and see if it helps.