cancel
Showing results for 
Search instead for 
Did you mean: 

Asus Rog Rapture GT6 doesnt save my changes

Jarvisit
Level 8

Hello, I've been using the ROG Rapture GT6 Mesh system for a while now and the settings I made are not saving. I am using the latest fw version on the site on both products. I couldn't find a beta version, and it doesn't support the Merlin system.

To better explain the problem of setting not registering:

 
Problems:
  • On both devices some of the settings are not saved. For example, if I remove the frequency of Wifi 5 GHz-2 band from automatic and save it to make it 108, the page refreshes and the old settings appear.
  • With the Intel BE200 WiFi 7 wifi card I get 400 mbps from about 30 cm (5 ghz-1 - channel 36).
  • I think the settings are not saved due to a problem with NVRAM, but there is also a signal problem. I get a very comfortable 1 Gbps wireless speed with the Huawei AX modem provided by ISP.

    My tries:
    • Both routers have been reset both from the interface and by hard reset method (WPS and Power key).
    • Both routers were tried separately as main devices.
    • They were connected via wifi and ethernet and set up via the interface.
    • Setup was also done with the mobile application.

      Does anyone else have this problem or know the solution?

296 Views
9 REPLIES 9

Saltgrass
Level 14

You need to get your primary router configured prior to adding the Mesh unit.

Once you have the mesh network configured, all changes to the primary router should propagate to the Mesh node.

I do not have those routers, so I cannot test.

Maximus Z890 Hero,
Intel Core Ultra 9 285K

Which is main router?

The one that is not being used as a AiMesh unit is the primary Router.

If your ISP gives you a Gateway which does Wi-Fi, have you bypassed that?

Maximus Z890 Hero,
Intel Core Ultra 9 285K

jzchen
Level 16

ASUS has a single firmware update listed on their US site:  3.0.0.4.388_24580 .  I'm afraid since they insist on customers using only that then any issues you're having should be directed to them to fix in a future update.

Jarvisit
Level 8

I cannot solve this problem then I send e-mail to Asus Custormer Service for beta fw. 

If what you are doing is changing the control channel for the upper 5 GHz radio, the 108 channel, may not be available so the router is correcting the error.

I am currently looking at a spectrum chart for an AXE16000 and it does not show any signals in the 108 area.  Try changing it to something in the 153 to 165 area and see if it sticks.

This, of course, may depend on where you are located.  But as far as I know, the GT6 is compatible with the US standards?

Maximus Z890 Hero,
Intel Core Ultra 9 285K

No, I live in Turkey. But when i first bought it, i can change and save every settings.

I suppose one other thing you might try is to look at the Administration section and Restore/Save/UploadSettings, or whatever your system has and see if using the Restore option might help.  Possibly, something has gotten corrupted and maybe just a reset, factory or otherwise, is not dealing with it.

Maximus Z890 Hero,
Intel Core Ultra 9 285K

I looked up channel 108 and it is a DFS channel.  As @Saltgrass notes this may not be available due to sharing with military/aviation.  Did you enable DFS channels?  A recent article for you:

https://www.asus.com/support/faq/1045936/