3 weeks ago
I wanted to know when the new BIOS will be released, at the moment 3067, because of the new BIOS, all the X3D processors that were tested go into error C5 with 1 plate, everything works fine, processors without an X3D console work in normal mode with Expo support, ADATA XPG Lancer RGB 2x16GB DDR5 6000MHz AX5U6000C3016G-DCLARBK memory was tested, g skill 2x 16GB F5-6000J3038F16GX2-TZ5NR, with the 7800 X3D CPU only the A2 slot works, with the 7900 X3D everything is the same, with the 7700X processor everything works fine in Expo
a week ago - last edited a week ago
Hello @ZIZ
Thank you for reaching out to us. We apologize for the delayed response due to a public holiday in our region and any inconvenience this may have caused.
Could you confirm if the two memory modules are installed in the DIMM_A2 and B2 slots?
When the system fails to boot as described, were any overclocking settings enabled? If so, which type of overclocking configuration was applied?
(Please note that the available overclocking options in the BIOS may vary depending on the installed memory modules.)
After clearing CMOS and without making any manual adjustments—including enabling EXPO—does the system boot properly with both modules installed?
In addition to the above checks, could you kindly provide the brand, model, and installation slots or ports of the GPU, SSD/HDD, and PSU?
Additionally, please record and share the boot status of all three CPUs when using one or two memory modules.
Thank you.