hello all im not new here just a looker bystander i got in to computers a few ( long ago ) and been building them for freinds and family there abouts a friend came up to me one day and said he needed a pc to do revit on and we sat down and thought of the things to go with it we did a few sketches of differnt layouts 
and what not's so this is where we started from 
and what not's so this is where we started from
then we had this after i built the system 
then was thinking it set out in the liveing room a bit much and from the lights it lights up most of the room lol so i came across a thread where the pc was built into a desk LP3 desk ( thanks for the inspation) so we sat out and started to see what the options was we went to office depot to see differnt pc desk and we came across one that just stuck out
then was thinking it set out in the liveing room a bit much and from the lights it lights up most of the room lol so i came across a thread where the pc was built into a desk LP3 desk ( thanks for the inspation) so we sat out and started to see what the options was we went to office depot to see differnt pc desk and we came across one that just stuck out
so we found the desk we are set to do the pc and get the closer off the floor 
and we thought it would look awsome with a pc built into it
and we thought it would look awsome with a pc built into it
then we decided to do it in metal so we sought out places to buy the material after we did it in sketchup and also in revit as well we found a place online to ship the material to us and so we waited and wahlaaaa we got the matrial in woohoo 
started weldin gthe frame but keep haveing tig problems and decided to alum wend the frame and pop rivit the rest of the case
