Der8Auer Ocean

[Marcocdi]

Hi.
With great pleasure I come to show you a simple project in terms of modding (ideas exist but since I am already a father, the time dedicated is different) in which i'll go through personalized watercooling, hybrid cooler for graphics card and some 3D printing.
At least that's what I have in mind in the short term.

Hardware:

- Lian Li PC-O Dynamic White
- i9 9900K
- Asus Maximus Formula XI
- 24Gb Gskill Trident Z 3200mhz CL15
- Asus Rog Strix Gtx 1080ti OC
- Old School Corsair AX750 80 Plus Gold
- SSD M.2 WD SN750 500Gb
- SSD Samsung 850 Evo 500Gb
- Toshiba 3TB HDD

Water cooling:
- EKWB Reve D5 PMW pump
- EKWB X-Res X3 150mm reservoir
- CPU block (possibly monoblock) under study
- Radiator EKWB Coolstream SE 360mm
- Radiator EKWB Coolstream SE 240mm
- 12x EKWB Connectors 13 / 19mm
- Tube Mayhems Clear
- 6x Corsair ML120 Pro white led

Let's see what this gives 🙂

[Marcocdi]

The house!










Lian Li worked hard on this box, what a build quality!
Superb design
More than enough space to play inside ...

Cumps
Marco from Portugal

[Marcocdi]

Hello again!
It seems that this montage will have beards: D, so little time I have for it due to work ... but I will get there.
Below I present an idea that occurred to me when I switched the MSI GTX 1080 SeaHawk Ek ... leaving a water graphics to air wanting to keep the loop in the graphics as well, now I would have to invest in a block for it ... but wait .. one day i buy another printing company i will have to invest again in another block ...: paranoid :: paranoid :: paranoid: nahh
Let's try to create a block that may be able to mount in future upgrades.

So I decided to go this way ...

Guinea pig: Asus Strix Gtx 1080Ti OC 11Gb
Victim: Asus Matrix Platinum Cooler
Responsible: EK Thermosphere cooper + plexi






The idea is then to create a universal hybrid cooler that allows me to mount it on future Gpu, s.
For now I'm just going to apply it to the graphics chip, but I already intend to match the cooling in the memories and come, just ahead.

Regards
Marco from Portugal

[Marcocdi]

HHello again.
A little more time spent on this project.
Block assembly test on 1080ti ...


Before the purchase, it already had an "incompatibility", which consists of the positioning of the chip in relation to the top of the board's pcb, which is superior to the clearing of the g1 / 4 hole in the block.




Life is made of challenges, so get to work and I will design an extension of the terminal block to place the G1 / 4 drilling axis above the pcb, for that I will have to increase this distance by at least 40mm ...
Basically, I needed less, but since the intention is to have a universal block, a day that changes graphics and the pcb is even "taller", these 40mm will be more than enough.

Regards

Marco from Portugal

[Marcocdi]

Here is 3D modeling for the extension of the ekwb block




It will also be made of acrylic, for the week I will already order the material in a company next to my job.
All channel machining will be done at the company where I work.

Regards

Marco from Portugal